The mark consists of a base which is a solid circle. Within the inner two-thirds of the circle are two connected symbols resembling the letters "AI". The "A" is an equilateral triangle with a 0-degree flat bottom. The right of the bottom side is shortened so as to disconnect from its right side, with the line having its end perfectly rounded off. The end of the right side that reaches the bottom angles outward to the right to connect to the "I", with an angle parallel to the triangle's bottom side. All outer angles of the triangle are perfectly rounded off, while inner angles are not rounded at all. The triangle has no fill, and the stroke is approximately 10% of the logo's overall width. The "I" is a vertical line with the same stroke and rounding specs as the "A". The bottom of the "I" is connected to the "A"'s extension coming off of its bottom-right side. The circle's top-left quadrant is squared off, as if a square is overlapping with its top-left corner at the same point of the circle's top-left squared area, and the bottom-right corner exactly at the circle's midpoint. Above the "I" is a shape resembling a light bulb with its metal base removed, filled with and without a stroke. The "light bulb"'s width and height are approximately double the width of the "I" just below. The gap between the "light bulb" and "I" is approximately 10% of the "light bulb"'s height. The top peak of the "light bulb" sits above the logo's "A" by the same amount of the stroke width for the "A". Within the "light bulb" is a "filament" drawn as a line with a stroke width 3.5x smaller than the stroke width of the logo's "A", and a stroke. The "filament" resembles the capital letter "M" with the "v" section of the letter lifted to half-height and duplicated horizontally. The angles of the two "v"s are 45 degrees, and the stroke and rounding specs match the "A" of the logo. The "filament" starts from the midpoint of the "light bulb", and its overall width is approximately 70% of the "light bulb"'s width. Below the logo's "AI" are the numbers "101", written with a rounded stroke. The gap between "101" and "AI" is double the gap between "I" and the "light bulb". Each "1" is 1.5x the stroke width of the "I", and the "0" is 2x the stroke width of the "I". Each number has all ends and angles perfectly rounded, and use justified spacing within the width of the "AI" causing the "1"s to be at the left and right sides of "AI" and the "0" to be in the center. The position of the "1"s are padded on the sides by half of the stroke width of the "I". The "1"s do not have a flat section on the bottom, and the left-side hook comes down to 1/3 from the top with the curve reduced to appear like half of a bubble. All of the inner contents of the logo should be perfectly centered within the circular base.
AI ONE HUNDRED ONE; AI ONE ZERO ONE
Color is not claimed as a feature of the mark.
Trademark: 90770987
